LOGO Commands and Procedures
Q.1. What is a LOGO?
Q.2. What is the full form of LOGO?
Q.3. What is the pen of LOGO Called?
Q.4. Why is the pen of LOGO called Turtle?
Q.5. What are the parts of LOGO Screen?
Q.6. Describe Main screen of LOGO?
Q.7. What are the commands in LOGO Called?
Q.8. Describe Commander window?
Q.9. What are the components of Commander Window?
Q.10. Describe the Command Input Box?
Q.11. Describe the Command Recall List Box?
Q.12. State the basic LOGO Commands?
Q.13. Which command is used to
i) move the turtle forward by a specified number of steps.
ii) move the turtle backward by a specified number of steps.
iii) turn the turtle towards right through a specified number of degrees.
iv) turn the turtle towards the left through a specified number of degrees.
Q.14. What do these commands do?
i) <PU>
ii) <PD>
iii) <HT>
iv) <ST>
v) <CS>
vi) <REPEAT>
Q.15. How is the print command used?
i) to print a word
ii) to print a sentence
Q.16. What is a LOGO Procedure?
Q.17. What are the parts of a LOGO Procedure?
Q.18. What are the rules for the content of the title of the procedure?
Q.19. How do you write a LOGO Procedure?
Q.20. How do you edit a LOGO Procedure?
Q.21. What do you mean by running a Procedure?
No comments:
Post a Comment